philips solar

philips solar

« Previous12345Next »

How to Make a Solar System Model from Scratch

Learn how to make a solar system model from scratch is a fun and also do not need any more knowledge about it. This article will give you a DIY guide "short but clear in the creation of a solar panel from scratch, i.e., things that do not serve you rather than throw it in the trash or things that are important but do not find employment at this time . So get ready to learn something new today by taking a few minutes to read this article.

Required documents:

The elements are the only things in and around your home and you do not need to try to buy something new to make a solar panel here. The necessary elements are as follows;

1. Screwdriver
2. A wood saw. (An electronic wood saw shall be preferred rather than a hand saw)
3. Soldering gun
4. Drilling machine
5. Copper wires
6. Cutter for cutting wires.
7. Paint brush.
8. Electrical Solder
9. Sheet of plexiglass.
10. Silicon caulk.
11. Rosin flux pen.

These were some of the elements that should make full use of zero elements that will be used to build a solar panel. The zero elements to be used are as follows:

• plywood or of considerable length and width
• tin or wire

However, there are certain elements that must be bought in a hardware store. The solar cells are UV protective. But even this can be avoided if you had used a solar panel now.

Procedure:

1. Wood cutting or dimensions that could satisfy all the solar cells and the painting of cut wood with a UV protective varnish.
2. Connect each cell or each of the other wires and solder. But before that, make sure to apply the flow of all outlets of the cells using flow resin pen.
3. Attach these cells or offset with touches of silicone caulk.
4. Make sure that the holes to hold the two wires that must be removed from the solar cell. Once the cables are fed through these holes is very important to close with the spheres of silicon.
5. The next step is to drill the plexiglass to hold the screws through them.
6. Or build a framework to support the Plexiglas.
7. With the help of screws or silicon and wood under Plexiglas containing solar cells.
8. And, therefore, the solar panel is ready. Make sure you have collected all the parts carefully.

About the Author

And, a step by step video showing you how to make a solar system model at home can be found on my favorite site. Click here to find out how you can save thousands on making your solar panels and save even more energy bills.

Rory Phillips - Solar Breakfast