solar garden stake

solar garden stake

« Previous12345Next »

Solar Patio lights can be a inexpensive way to enhance safety and beautify your patio. Designing a layout and installing them can be done quite easily. Here are simple steps to installing solar patio lights.

Solar Patio lights provide light to your patio area. They have two purposes: to provide safety and to beautify your patio. Since solar patio lights generate their energy from the sun, they do not negatively affect the environment while adding a sense of warmth and light to your homes. There are also very economical to operate.

Here is a simple and important consideration many people forget when installing solar patio lights:

They must be positioned and installed in places where they can be properly exposed to both the sun during the day and to provide adequate illumination at night.

Here are simple steps on how to properly install solar patio lights.

Step 1: Identify areas that need lighting

These are areas with small steps and dark corners or edges that are not easily seen in the dark. If left unlit, they could result trip or fall accidents that may range from minor-severe.

These areas are considered "critical areas."

Step 2: Mark the identified areas using a garden stake.

Step 3: Make sure that the space or location between each additional patio light is evenly measured.

Find the position for your pole-mounted solar lights on patio deck posts (or exterior wall). The spots must be properly marked too.

Step 4: The marked area must be exposed to sunlight throughout the day

This is very important since solar patio lights need the rays of the sun in order to operate in the evening. Leaving them hidden from sunshine promises a dark patio all throughout the night.

If there is foliage that blocks that sun's powerful rays, make sure that you trim the area.

If you don't want to cut them, you can move the garden stake markers to a more exposed area.

You may also move the solar light fixture to the other side of the post (if it's pole-mounted).

Step 5: Dig a hole where the marker is located

This is where you will bury one half of the patio light's stake. Therefore, the whole must be deep.

Set it deep enough into the hole.

Hold the stake in place as you fill the hole with soil again.

When you're done back filling it with soil, tamp it with your foot. After that add more soil and tamp it once again. This will ensure you that the lighting stake is firmly in place.

Step 6: Properly hold the pole-mounted fixture in its place, against the post or a wall.

Use a pencil to mark the screw holes.

Pre-drill the holes.

Use an electric drill screwdriver to screw the bracket into place.

Connect the fixture to the bracket and tighten it well.

Installing solar patio lights is quite easy and anybody can do it. Make sure you follow the guidelines mentioned here. You may also install an alarm system or a motion detector device to further improve the safety and security of your home. These devices should be able to aid you in deterring intruders while adding beauty to your house in the process.

For more information on securing the outside of your house you can go here to: solar motion light solar motion light. Also, here is where you can learn more about Outdoor Flood Light which are very popular for securing a home.

Snowman Solar Stake